Re: Simulator for x486

Helge Kruse wrote:
Hello,

I am working at a boot loader for a x486 CPU. The CPU starts from Flash in 8086 real mode initializes the GDT, jumps to protected mode and sets up the chip set, DRAM controller etc.

Is there any simulator where I can single step the opcodes out of the flash rom image? Host operating system ist Windows XP, Linux would be possible but harder to set up.

/Helge

--
Time is an ocean but it ends at the shore.


BOCHS <bochs.sourceforge.net>

.

Relevant Pages

  • Simulator for x486
    ... The CPU starts from Flash in 8086 real mode initializes the GDT, jumps to protected mode and sets up the chip set, DRAM controller etc. ...
    (comp.lang.asm.x86)
  • Re: ITV gives Silverlight the heave ho
    ... I'm not sure if Flash is using GPU assisted decoding under OS X. ... I'm not sure if it's using it under Windows either. ... If it's not using the CPU or graphics card, ... load (depending on the Mac and the stream). ...
    (uk.comp.sys.mac)
  • Re: Some websites cause CPU power to max out
    ... maxed out one core on my MacBook Pro and was rapidly chewing through the ... It makes heavy use of Flash on its web site. ... wccorradio uses about 30% of the CPU capacity on my MBP 17/2.6 GHz.* ...
    (comp.sys.mac.system)
  • Re: Implement ARM cores on a FPGA chip?
    ... CPU in FPGA compared to standard microcontrollers. ... Flash memory usually ... At higher speeds, you run from RAM or flash with caches. ...
    (comp.arch.fpga)
  • Re: Implement ARM cores on a FPGA chip?
    ... CPU in FPGA compared to standard microcontrollers. ... Flash memory usually ... At higher speeds, you run from RAM or flash with caches. ...
    (comp.arch.fpga)