Re: Recommendations for LCD

From: Ivo Bauer (abuer_at_zom.zc)
Date: 11/28/04


Date: Sun, 28 Nov 2004 15:05:02 +0100

danny heijl wrote:
> I now have a Sony SDM-X93 and I like it very much (using one of the DVI
> connectors). I had a 17 inch LG before that, I liked that one too but
> the letters were just that tiny bit too small to be comfortable for long
> editing sessions, and the viewing angle was not that good.

Thanks for the hint, I'll take a look at it. Currently I have 17" BenQ
FP767 and I'm suffering from the same symptoms you described. My
ophtalmologist told me to decide either buy a better LCD or starting
to wear glasses. :-)

-- 
Ivo Bauer
Software Developer
OZM Research, s.r.o.
http://www.ozm.cz/
Turn your Delphi application into Modbus client/server with ModLink!
http://www.ozm.cz/ivobauer/modlink/


Relevant Pages

  • Re: Lettering on metal
    ... This is an art type project. ... Anyway, I need to put three initials on it, about 3/4 inch high. ... I could either brush it so the letters are bright, or, gild it with gold. ... Not at all married to the above technique. ...
    (rec.crafts.metalworking)
  • Re: Lettering on metal
    ... This is an art type project. ... Anyway, I need to put three initials on it, about 3/4 inch high. ... Print the letters on paper, ... I did a perfect circle using handwheels and turning them by precisely ...
    (rec.crafts.metalworking)
  • Re: Lettering on metal
    ... This is an art type project. ... Anyway, I need to put three initials on it, about 3/4 inch high. ... Print the letters on paper, ... Not at all married to the above technique. ...
    (rec.crafts.metalworking)
  • Re: Lettering on metal
    ... This is an art type project. ... Anyway, I need to put three initials on it, about 3/4 inch high. ... Print the letters on paper, ... As DIY option, laser print the letters onto a sheet of stick on mylar, ...
    (rec.crafts.metalworking)
  • Re: Lettering on metal
    ... This is an art type project. ... Anyway, I need to put three initials on it, about 3/4 inch high. ... I could either brush it so the letters are bright, or, gild it with gold. ... As DIY option, laser print the letters onto a sheet of stick on mylar, ...
    (rec.crafts.metalworking)