Object Inspector position/size

hello,

i want to change the position and size of the Object Inspector inside delphi
ide.
if I load a new project, it automatically resets to the original position.

Is there anyway to enforce it stay on the position I want?

Thanks


.

Relevant Pages

  • Re: First hours with Delphi 2006.
    ... Comparing to Delphi 2005 IDE have same terrible load time. ...
    (borland.public.delphi.non-technical)
  • Re: Object Inspector position/size
    ... if I load a new project, it automatically resets to the original position. ... You said you changed the position and size of the object inspector and then loaded a new project and it restored to the default IDE. ...
    (borland.public.delphi.thirdpartytools.general)
  • Re: Object Inspector position/size
    ... i want to change the position and size of the Object Inspector inside delphi ide. ... if I load a new project, it automatically resets to the original position. ... I use C Builder but I am assuming the IDE works the same way. ...
    (borland.public.delphi.thirdpartytools.general)
  • Re: D2005 update 4 works.
    ... double click on each units name to load into the IDE all the units. ... After clicking the last Unit, Delphi will take the control and parse throught all unit in reverse order (unit displayed in the project manager, from last displayed to the 1rst displayed). ...
    (borland.public.delphi.non-technical)
  • Re: Late majority
    ... Actually I prefer a bit of loading time up front vs having to wait ... Ok, load up a project... ... I'd rather wait 15 seconds up front (which I do with delphi 2006) than ... to "constantly" wait 5-15 seconds while using the ide. ...
    (borland.public.delphi.non-technical)