Extra addr. lines needed

From: John Tan (bktan1974_at_netscape.net)
Date: 12/29/03 

Date: 28 Dec 2003 23:09:41 -0800

Hi,
I'm using an 8052 that has 12 addr lines ~ 4KB of addressable space.
But i need to access additional 512KB of ROM ~ 19 address lines
required!

How do i extend the addr. to 19 lines.

Can i do this:

1) get firmware engineer to extend it using GPIO pins ? Is this a good
method ?
2) some kind of paging access ? how exactly, i not too sure in terms
of HW wiring ?

Thanks.

Relevant Pages

  • Re: Extra addr. lines needed
    ... > How do i extend the addr. ... > of HW wiring? ... Will a serial device work for your application? ...
    (comp.arch.embedded)
  • Re: Extra addr. lines needed
    ... John Tan wrote: ... > How do i extend the addr. ... chunks overlaying the same addresses, then have some calling program in ...
    (comp.arch.embedded)
  • Extra addr. lines needed
    ... But i need to access additional 512KB of ROM ~ 19 address lines ... How do i extend the addr. ... of HW wiring? ...
    (comp.arch.embedded)
  • Re: Extra addr. lines needed
    ... In article, John Tan ... >How do i extend the addr. ... >1) get firmware engineer to extend it using GPIO pins? ...
    (comp.arch.embedded)
  • Re: Productive weekend
    ... entire feed to the garage is one big spur. ... Now you've let me know of the full extent of the wiring woes, may I suggest replacing the 18-amp "fuse" with some wire to match the original, then put in a single pattress with 13 amp fuse to protect the rest of your new wiring. ... I'm soooo pleased you didn't go with your original plan of 1.0mm lighting wire to extend your 32amp-fused spur ...
    (uk.rec.motorcycles)