Atmel Programmer

From: --|-- (chrispol_at_videotron.ca)
Date: 01/25/04 

Date: Sat, 24 Jan 2004 20:35:41 -0500

http://www.lancos.com/e2p/avrisp-stk200.gif

ok i built the above programmer using an at90s2312 also completed crystal
circut......

anyhow long story short, i can read security descriptors, but anything else
failes the led also never lights up, the par port is giving me 4.6 volts and
96ma but the power drastically drops when i run an action, vcc to the atmel
only carries 2.1 volts or so ...

Any ideas?
 been over the circut 30 times it matches......

Relevant Pages

  • Re: Question about 74HCT and 74HC logic ICs
    ... and it calls for 74HCT series logic ICs. ... levels which are only guaranteed to be above 2.4 volts for a high. ... volt threshold for a logic 1. ... the EEPROM programmer I'm working on connects via PC ...
    (sci.electronics.components)
  • Re: Flash code corruption on pic6f870
    ... You could have a point there, im sure the programmer doesn't verify at ... anything other than 5 volts but do any? ... at it's max and min supply voltages is a test worth doing, ...
    (comp.arch.embedded)