Re: Minimalist PC Needed for embedded App
patrick_at_klos.com
Date: 06/24/04
- Next message: Walter Driedger: "Re: PID Engine RPM Controller"
- Previous message: dannynews: "a good DVR SoC?"
- In reply to: Ben Nguyen: "Minimalist PC Needed for embedded App"
- Next in thread: Pete Fenelon: "Re: Minimalist PC Needed for embedded App"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: 24 Jun 2004 01:15:16 GMT
In article <e604be8.0406231543.77e29fb8@posting.google.com>,
Ben Nguyen <benn686@hotmail.com> wrote:
>Hi,
>
>Im looking for a tiny pc for an embedded app. The only requirements
>I need, is that it be
>1) 486 compatable,
>2) Has 1 Serial Port
>3) Run Dos (via Disk-On-Chip preferred)
>4) SMALL (ala PC-104 or smaller)
>
>
>I DONT need vga, hard drive, or floppy support, but I would need
>to be able to download new appliactions to the DOC via serial.
>
>Anyone know where I might find such a beast?
You could check out aCROSSER for a $104 board (add your own
flash and RAM I think) that'll do a nice job:
http://www.acrosser.com/104promotion.htm
We haven't seen these yet ourselves, but we did order a few
to play with.
There are others I'm sure, but this is the one that comes to mind
since we were looking this week.
========= For LAN/WAN Protocol Analysis, check out PacketView Pro! =========
Patrick Klos Email: patrick@klos.com
Klos Technologies, Inc. Web: http://www.klos.com/
==================== What goes around, comes around... =====================
- Next message: Walter Driedger: "Re: PID Engine RPM Controller"
- Previous message: dannynews: "a good DVR SoC?"
- In reply to: Ben Nguyen: "Minimalist PC Needed for embedded App"
- Next in thread: Pete Fenelon: "Re: Minimalist PC Needed for embedded App"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|