PC 104 Question

From: Norm Dresner (ndrez_at_att.net)
Date: 08/28/04

  • Next message: Leon Heller: "Re: 16F628 beginner's book?" 
    Date: Sat, 28 Aug 2004 13:07:07 GMT

    If I have an x86 CPU board with a PC 104 connector, will devices attached to
    the PC 104 bus look to the software just like any device attached to the ISA
    bus or do I need to write special drivers to control the peripherals?

    TIA
        Norm

  • Next message: Leon Heller: "Re: 16F628 beginner's book?"

    Relevant Pages

    • Re: Compaq SCSI drives, Convertors and AHA-2940 PCI cards HELP??!
      ... board) connector lead. ... Compaq 9.1 GB Wide Ultra Scsi3 Drives, ... it provides a power connector, configuration jumpers (for the SCSI ID, ... a narrow bus and one for a wide bus. ...
      (comp.periphs.scsi)
    • Re: Can I route a PCI Clock line longer than 2ns?
      ... bus, which has six slot and 3 inches between each. ... The spec says 4 slots is the maximum you can have on a PCI ... Leaving 20pF/6 or about 3pF per connector. ... The spec gives examples based on "loads", where an add-in card is ...
      (sci.electronics.design)
    • Re: DB9 Alternatives
      ... > I'm looking for an alternative connector for a serial port. ... Smaller modules can get their power from the bus, ... bus and runs as the single master in this master-slave system. ...
      (comp.arch.embedded)
    • Re: Can I route a PCI Clock line longer than 2ns?
      ... bus, which has six slot and 3 inches between each. ... The spec says 4 slots is the maximum you can have on a PCI ... Leaving 20pF/6 or about 3pF per connector. ... The spec gives examples based on "loads", where an add-in card is ...
      (sci.electronics.design)
    • Re: [OT] ATX-PSU and amperage on connectors...
      ... then the 4pin HDD connector need already ... 12V is from bus 1. ... the PSU. ... On my Workstation I am testing a IDE/CF-Adapter with a 4 GByte SanDisk ...
      (Debian-User)