Re: Picoweb Project

From: Otto (ohaldi_at_freesurf.ch)
Date: 01/05/05 

Date: Wed, 05 Jan 2005 20:56:45 +0100

In article <41DBFA0D.FED2DDE2@no.spam>, Richard H. wrote:
> Go ahead. Many folks here have experience with the AVR. I've built the
> breadboard version of PicoWeb, but I've not used his source code.
>
I have a source and can't do what I wont. I like to modify it, but have
some problem. And I won't disturb this forum with my source!

> Also, if your questions are very PicoWeb-specific, you could also ask
> Bruce Lightner directly. I found him very willing to answer questions.
>
I send 2 or three e-mails to lightner but never get any answer!

Otto

Relevant Pages

  • Re: similar development boards to the "Parallax Professional Development Board"
    ... Gordon McComb wrote: ... like to have one for AVR microcontroller. ... pin cables so attach ports to a separate breadboard. ... You can use most anyone's compiler with the board. ...
    (comp.robotics.misc)
  • Re: similar development boards to the "Parallax Professional Development Board"
    ... like to have one for AVR microcontroller. ... even an SD card) are already attached. ... pin cables so attach ports to a separate breadboard. ... You can use most anyone's compiler with the board. ...
    (comp.robotics.misc)
  • Re: Crystal problems/questions
    ... > have built. ... > put this processor on a breadboard, hook up some of the basics like Vdd, ... > oscilloscope to probe it. ... Someone I know breadboarded a PIC circuit and didn't bother using capacitors ...
    (sci.electronics.design)
  • Re: unknown card
    ... robotics gizmo is currently built on two small breadboards, ... No - More like a "blank experimenter card" type thing, only with a breadboard on it. ... Music synthesis for 8-bit Apple II's! ...
    (comp.sys.apple2.marketplace)
  • Re: schematic vs breadboard
    ... I am trying to build a simple A/D convertor from a schematic on my ... Now, I've built something, but I'm not sure that it's wired ... The following link will show a picture of my breadboard and from the ... Pin 1 should be the pin with the dot next to it. ...
    (sci.electronics.basics)