Bistable relays

From: Phil (please_at_sendmejunkmail.com)
Date: 02/10/05 

Date: Thu, 10 Feb 2005 21:43:31 GMT

Anyone ever had a problem with bistable's becoming
tristable's??
I have a bistable that breaks contact if the relay
next to it on the PCB operates, having gently tapped the
relay the comon is not connected to either the NO or NC.
Having quicky tapped a few they all seem to lose contact
with either NO or NC.

Anyone else seen this problem?

Phil

Relevant Pages

  • Re: Bistable relays
    ... Phil wrote: ... > Anyone ever had a problem with bistable's becoming ... > relay the comon is not connected to either the NO or NC. ... Noel ...
    (comp.arch.embedded)
  • Re: Bistable relays
    ... >> Anyone ever had a problem with bistable's becoming ... >> relay the comon is not connected to either the NO or NC. ... Is it possible that it is a contact problem - e.g. using non-gold contacts for signal switching ...
    (comp.arch.embedded)
  • Re: Bistable relays
    ... > Anyone ever had a problem with bistable's becoming ... > relay the comon is not connected to either the NO or NC. ... Sounds like the magnetic field from the adjacent relay is affecting the ... Rob ...
    (comp.arch.embedded)
  • Re: Touch-switch mouse for RSI sufferers
    ... Hi, Phil. ... Since you only need one normally open relay contact, ... components to avoid shorting out the +5V and save the transistor. ... If you're really pressed for space, the 10K resistor is the most ...
    (sci.electronics.basics)
  • Re: Computer control of an audio multiplexor
    ... controlled matrix is the most cost effective method. ... controlled relay card but all I could find had SPDT relays and he wants ... So the $25 National Instruments 24-bit parallel I/O cards that are also ... Combine the free or low-cost electronic PCB and microcontroller programming ...
    (comp.home.automation)