20MHz PIC on solderless board?
From: Louis Levin (loulev_at_arcotech.com)
Date: 02/16/05
- Next message: shrinivasnh_at_gmail.com: "how to use keybd_event inkeypad driver"
- Previous message: Tesvit: ""C" source code for I2C slave PIC16F81x"
- Next in thread: NewsGroup: "Re: 20MHz PIC on solderless board?"
- Reply: NewsGroup: "Re: 20MHz PIC on solderless board?"
- Reply: Luhan Monat: "Re: 20MHz PIC on solderless board?"
- Reply: Michael: "Re: 20MHz PIC on solderless board?"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Wed, 16 Feb 2005 16:44:29 +1100
What is the concensus on using PIC's at 20MHz on a solderless
prototyping board? In particular, a 16F628A with external crystal.
Purists please note, this is just for proof of concept stuff, not fine
tuning a design.
If there are major problems, is there any way around them? Maybe a few
extra bypass caps on the rows tied to the oscillator?
Thanks for any advice.
Louis
- Next message: shrinivasnh_at_gmail.com: "how to use keybd_event inkeypad driver"
- Previous message: Tesvit: ""C" source code for I2C slave PIC16F81x"
- Next in thread: NewsGroup: "Re: 20MHz PIC on solderless board?"
- Reply: NewsGroup: "Re: 20MHz PIC on solderless board?"
- Reply: Luhan Monat: "Re: 20MHz PIC on solderless board?"
- Reply: Michael: "Re: 20MHz PIC on solderless board?"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
