Re: Timing Diagram Editors
From: Arie de Muynck (send.spam.to_at_spammer.org)
Date: 02/17/05
- Next message: Nju Njoroge: "PPC 405 in Virtex 2 Pro 30-Turning off "Critical-word first" loads"
- Previous message: Heinz-Jürgen Oertel: "Re: Canopen sending visible string via segmented sdo upload"
- In reply to: James Beck: "Timing Diagram Editors"
- Next in thread: Anton Erasmus: "Re: Timing Diagram Editors"
- Reply: Anton Erasmus: "Re: Timing Diagram Editors"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Thu, 17 Feb 2005 23:34:48 +0100
"James Beck" ...
> Does anyone make a DECENT timing diagram editor?
> I don't need any timing analysis, just some pretty graphics to help get
> some information across to some techs that do not speak English very
> well, and I'm sure the data will be needed for a manual as well. The
> timings are in milliseconds, not ns and my googling has led to some
> pretty expensive dead ends.
I often use ASCII, fixed font:
________________________________
___| |_______
____
__________________________| |____________
________________ __ ___ ____
---<________________X__X___XXXXX____>-------
0 1 2 2 3 4
0 signal starts tri-state
1 turnon
2 transition
3 illegal / undefined
4 goes tri-state
Note the upper trace (enable) changes just before the result (tri-state on
and off), etc.
-- Regards, Arie de Muynck
- Next message: Nju Njoroge: "PPC 405 in Virtex 2 Pro 30-Turning off "Critical-word first" loads"
- Previous message: Heinz-Jürgen Oertel: "Re: Canopen sending visible string via segmented sdo upload"
- In reply to: James Beck: "Timing Diagram Editors"
- Next in thread: Anton Erasmus: "Re: Timing Diagram Editors"
- Reply: Anton Erasmus: "Re: Timing Diagram Editors"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|