Re: Slightly OT - Nearfield probe for EMI sniffing


> Anyone know the best way to handbuild a nearfield
> probe for a spectrum analyzer? I'd like to do
> some EMI sniffing before going to the lab. My

We use a rubber ducky antenna scrounged from an old ham radio.

.

Relevant Pages

  • Re: Slightly OT - Nearfield probe for EMI sniffing
    ... >probe for a spectrum analyzer? ... >some EMI sniffing before going to the lab. ...
    (comp.arch.embedded)
  • Slightly OT - Nearfield probe for EMI sniffing
    ... probe for a spectrum analyzer? ... some EMI sniffing before going to the lab. ...
    (comp.arch.embedded)
  • Re: Pulling crystal
    ... One was that my scope probe capacitance ... However, the spectrum analyzer is ... oscillator, the radiated signal from the oscillator is picked up. ... I had the solder joints on my board touching ...
    (rec.radio.amateur.homebrew)
  • Re: Slightly OT - Nearfield probe for EMI sniffing
    ... probe for a spectrum analyzer? ... I'd like to do some EMI sniffing before going to the lab. ... My attempts at using a couple turns of wire at the end of a piece of coax don't seem to work well. ...
    (comp.arch.embedded)