Re: Slightly OT - Nearfield probe for EMI sniffing

On Fri, 20 May 2005 09:38:09 -0700, in comp.arch.embedded Jim Stewart
<jstewart@xxxxxxxxxxx> wrote:

>Anyone know the best way to handbuild a nearfield
>probe for a spectrum analyzer? I'd like to do
>some EMI sniffing before going to the lab. My
>attempts at using a couple turns of wire at the
>end of a piece of coax don't seem to work well.
an70 from www.linear.com
page 54 onwards



martin

After the first death, there is no other.
(Dylan Thomas)
.

Relevant Pages

  • Slightly OT - Nearfield probe for EMI sniffing
    ... probe for a spectrum analyzer? ... some EMI sniffing before going to the lab. ...
    (comp.arch.embedded)
  • Re: Slightly OT - Nearfield probe for EMI sniffing
    ... > Anyone know the best way to handbuild a nearfield ... > probe for a spectrum analyzer? ... > some EMI sniffing before going to the lab. ...
    (comp.arch.embedded)
  • Re: Slightly OT - Nearfield probe for EMI sniffing
    ... probe for a spectrum analyzer? ... I'd like to do some EMI sniffing before going to the lab. ... My attempts at using a couple turns of wire at the end of a piece of coax don't seem to work well. ...
    (comp.arch.embedded)
  • Re: What Did You Watch? September 18 (Friday)
    ...  Why is she unemployed when Allison ... data from the probe. ... but not if she was running a lab. ... Ian (P.S. Has this show referenced knowledge of 'Nemesis' before?! ...
    (rec.arts.tv)
  • Re: Pulling crystal
    ... One was that my scope probe capacitance ... However, the spectrum analyzer is ... oscillator, the radiated signal from the oscillator is picked up. ... I had the solder joints on my board touching ...
    (rec.radio.amateur.homebrew)