Re: ld terminated with signal 11

When I don't use a make file, I can compile and link the above program.
After compilation, I used the file command to verify that it was an
ARM executable. However, when I copy the program to a Zaraus 5600 PDA
and attempt to execute it, I get:

hello_arm: command not found.

Any ideas?

-Vance

.

Relevant Pages

  • Re: cobol & libraries on 11i v2
    ... ld: Ignoring +allowunsats. ... be does not match the type of the compile (PA vs IA, ... compile What does the file command say for ... *** Error exit code 1 ...
    (comp.sys.hp.hpux)
  • Re: Compiling Fortran in 32 bit mode
    ... The code I'm trying to compile is intended for use in ... Matlab 6.5, which does not support 64bit applications. ... Here's the compiler commands I'm using: ... Use the file command, which should tell you the mode information ...
    (comp.lang.fortran)
  • Re: unix screen command
    ... No effort was made to verify the identity of the sender. ... >thx very much for help ... just run that and it should compile and link an executable ...
    (comp.os.vms)
  • Re: [JANITOR PROPOSAL] Switch ioctl functions to ->unlocked_ioctl
    ... You should probably restrict yourself to files that you can at least ... I've been silly in didn't verify whether the file compile ... better off trying to gain experience with some other project -- the ...
    (Linux-Kernel)
  • Re: Kernel Cross Compiling
    ... >>automated kernel builds for different architecture, ... >>given patch breaks that compile on any of the tested ... what archs did you verify? ... send the line "unsubscribe linux-kernel" in ...
    (Linux-Kernel)