Re: Parallel Port Wigglers PCI Cards and XP

> If you do have it working, what brand of PCI parallel port card did
> you use?

I don't have a wiggler, but my embedded systems are connected to the host
via parallel ports for cross debugging. To be able to connect 3 systems at
the same time, I added a PCI card from SUNIX (http://www.sunix.com.tw/).
Downloading over the SUNIX ports is faster than over my legacy LPT1 port on
the motherboard. The SUNIX ports support Centronics, ECP, EPP, etc. I quite
happy with this card.

Peter



.

Relevant Pages

  • Re: [RFC/CFT] Split 8250 port table (part 2)
    ... The only ports which remain in asm-*/serial.h are the platform specific ... * The following define the access methods for the HUB6 card. ... the interrupt is at irq3 ...
    (Linux-Kernel)
  • Process in biowr state
    ... I setup the card from another machine, then booted it, and then wanted to install the manpage distribution. ... miibus0: on vr0 ... miibus1: on vr1 ... usb1: companion controller, 4 ports each: usb0 ...
    (freebsd-questions)
  • Re: 1-wire to USB converter that can use 1820s directly
    ... than to need to add another PCI card to support serial ports. ... how someone could finally say "not one more f'ing wire!" ...
    (comp.home.automation)
  • Re: ARCHIEVE, RESTORE and flag handling
    ... it does not clear ports 1-3. ... Is the entire backup segregated into a directory ... The idea is to take a formatted SD card and make a copy ... from where it could be executed, ending with RESTORE; ...
    (comp.sys.hp48)
  • Re: ng_fec and cisco 2931
    ... >4 ports) has determined that it appears to have a 100 megabit limit to ... >card in total. ... I have a 3com (xl0) and a davicom 9102 ... ngctl msg dc0: setpromisc 1 ...
    (freebsd-performance)