Re: microcontroller selection

Or an unlooper.

"Greg the Grog" <shem_an_na@xxxxxxxxxxxxxxxxxx> wrote in
news:gZLBf.226857$V7.171816@xxxxxxxxxxxxxxxxxxxxxxxxxx:

>
> "Ulf Samuelsson" <ulf@xxxxxxxxxxxxx> wrote in message
> news:dr5rii$qg7$1@xxxxxxxxxxxxxxxxxxxxxxxxxx
>>> Hi, I want to select a 8 bit microcontroller which can be run under
>>> 3V and with 12MHz clock. Any choice?
>>>
>>
>> I think a requirement for a 12 Mhz clock is a bit strange.
> Smells of USB?
.

Relevant Pages

  • Re: Need help in converting YUV to RGB using OV7620
    ... PCLK at 5Mhz. ... Firstly you have NOT checked that your microcontroller can accept data ... ONE clock edge, whilst UV is clocked out at 10MHz by using the rising ... work either on BOTH edges of the PCLK signal or to two ports that can ...
    (comp.arch.embedded)
  • Re: Help me solve this design problem PLEEEZ
    ... any single chip microcontroller could handle the job - the ... >> clock the microcontroller at 32.768kHz. ... which added with some logic gates allows the first timer to work ...
    (sci.electronics.design)
  • Re: need a prog to pause
    ... that comes to mind is to count about 5 clock ticks of the timer ... unsigned short temp = CLOCK; ... microcontroller can in a never ending loop to update a monitor display. ... However in about an hour the PC overwrites some values on the ...
    (comp.os.msdos.misc)
  • Re: Help me solve this design problem PLEEEZ
    ... > that needs a 24-bit counter, for which you could use the LSI LS7166 ... any single chip microcontroller could handle the job - the ... > clock the microcontroller at 32.768kHz. ... which added with some logic gates allows the first timer to work ...
    (sci.electronics.design)
  • Re: PS/2 mouse interface with 8052 microcontroller
    ... >extra hardware I cannot interface the mouse directly with the UART ... >(serial port) of the microcontroller (mouse has data and clock lines; ... The mouse generates the clock, the data is latched on one of the edges,I forget ...
    (comp.arch.embedded)