Re: paradigm locate 5.0 for 80188: insufficient memory?
- From: "vax9000" <VAX9000@xxxxxxxxx>
- Date: 6 Apr 2006 16:36:10 -0700
Ignacio G.T. wrote:
...
The solution to these problems is to *reduce* the amount of "real-mode"
available memory below 512K.
If you are using a W2K machine, you can do this executing command.com
(not cmd.exe!) and mem.exe several times until you see that the memory
available to MS-DOS programs is less than 512 K. Then, launch locate.exe
and cross your fingers. This has saved my day several times.
Thank you for the tip. However, it does not work with paradigm locate.
I ran command.com several times until the available 'triditioanl'
memory was lower than 512K. But still this error message was printed
when I ran "locate bsimrom".
vax, 9000
.
- References:
- paradigm locate 5.0 for 80188: insufficient memory?
- From: vax9000
- Re: paradigm locate 5.0 for 80188: insufficient memory?
- From: Ignacio G.T.
- paradigm locate 5.0 for 80188: insufficient memory?
- Prev by Date: Re: ARM dev board
- Next by Date: Re: paradigm locate 5.0 for 80188: insufficient memory?
- Previous by thread: Re: paradigm locate 5.0 for 80188: insufficient memory?
- Next by thread: Re: paradigm locate 5.0 for 80188: insufficient memory?
- Index(es):
Relevant Pages
|