Re: Where to get small 3 digit LCD?
- From: "steve" <bungalow_steve@xxxxxxxxx>
- Date: 25 May 2006 07:02:29 -0700
Peter wrote:
You don't need to line up the zebra stripe connectors, you just have to line
up the PCB with the display. Put enough pressure on the PCB and display to
make contact. The stripes are alternate conductor and insulator so as long
as your pads have enough spacing they won't short out.
Peter
Oh, yes, now I understand, I looked at the stripes under a magnifying
glass and the conducting strips are very narrow, so it doesn't matter
how it's lined up, very neat! (who invented this thing). It does look
like it has to be compressed quite a bit, the rubber strip is quite a
bit thicker then the space between the LCD glass and pcb board, I still
have to think of good way to prototype these parts, there doesn't seem
to be a easy way to verify the connection, thanks
steve
.
- References:
- Where to get small 3 digit LCD?
- From: steve
- Re: Where to get small 3 digit LCD?
- From: Peter
- Where to get small 3 digit LCD?
- Prev by Date: Re: Low cost weight sensor ?
- Next by Date: Re: Low cost weight sensor ?
- Previous by thread: Re: Where to get small 3 digit LCD?
- Next by thread: System MIPS calculation
- Index(es):
Relevant Pages
|
