beginner and 8051

Hi All,
I'm a beginner and I'd like to start from 8051 . as I can see-the only
cheap boards with jtag are from silabs, right? there are a few of them
for about 70$ , which one should I buy?
will I be able easily move my code to other 8051 mcu like ats89s?

thanks.

.

Relevant Pages

  • Re: beginner and 8051
    ... cheap boards with jtag are from silabs, ... Make sure your program is well structured, with direct access to the peripherals only in clearly limited sections of the code. ...
    (comp.arch.embedded)
  • Re: beginner and 8051
    ... cheap boards with jtag are from silabs, ... pcb, here is one: ...
    (comp.arch.embedded)
  • Re: C8051F330 serial port programmer
    ... Just got back from support with silabs. ... JTAG means a whole lot of programming compared with rs232. ... Unfortunately Silabs didn't publish the debugging hooks of the micros ...
    (sci.electronics.design)
  • Re: 8051 Emulator
    ... Keil uVision 2 debugger through a silab jtag interface. ... You must work for Silabs! ... JTAG and an Emulator. ... JTAG or ISP. ...
    (comp.arch.embedded)
  • Re: beginner and 8051
    ... cheap boards with jtag are from silabs, ... an alternative is start with an at89s52 or similar atmel parts is available a almost-0 component programmer (trough the PC parallel port) so you can start with a home built proptotype board. ... max232 you can build a system that is able to receive code trough the serial port write in the ram and execute from there. ...
    (comp.arch.embedded)