Re: beginner and 8051

In article <1149092718.013127.315400@xxxxxxxxxxxxxxxxxxxxxxxxxxxx>,
noemail12000@xxxxxxxxx <noemail12000@xxxxxxxxx> writes
actually, I was thinking about at89s. the only reason I asked about
silab is their development board with jtag for about 70$.
but, how usefull jtag is? can I get the same result with software
simulator?

There are various simple serial programers you can make for the Atmel
51's



mmm wrote:
noemail12000@xxxxxxxxx wrote:
Hi All,
I'm a beginner and I'd like to start from 8051 . as I can see-the only
cheap boards with jtag are from silabs, right? there are a few of them
for about 70$ , which one should I buy?
will I be able easily move my code to other 8051 mcu like ats89s?

thanks.


an alternative is start with an at89s52 or similar atmel parts is
available a almost-0 component programmer ( trough the PC parallel port
) so you can start with a home built proptotype board.

there are lot of hardware/software project on 8051 available on the net.

with an at98s5x an old static ram an a 74hc373 o 74hc573 a 74hc00 and a
max232 you can build a system that is able to receive code trough the
serial port write in the ram and execute from there.

BTW the controller must be preprogrammed with one of the monitor
available on the net


--
\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\
\/\/\/\/\ Chris Hills Staffs England /\/\/\/\/
/\/\/ chris@xxxxxxxxxxxx www.phaedsys.org \/\/\
\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/



.

Relevant Pages

  • Re: beginner and 8051
    ... silab is their development board with jtag for about 70$. ... available a almost-0 component programmer (trough the PC parallel port ... max232 you can build a system that is able to receive code trough the ...
    (comp.arch.embedded)
  • Re: beginner and 8051
    ... silab is their development board with jtag for about 70$. ... but, how usefull jtag is? ...
    (comp.arch.embedded)
  • Re: Reading file on DM642 with CSS 3.0.0.21
    ... JTAG can make a big difference. ... I've used file io with both a PCI XDS560 and a USB XDS510, ... While I guess a parallel port emulator would be slower ...
    (comp.dsp)
  • Re: C8051F330 serial port programmer
    ... just made a parallel port programmer for f8051f330d in two hours, ... The JTAG code is most likely out there and free. ... I don't like their keeping the details of the debugging stuff secret ... parallel port downloading cable are some 470R resistors. ...
    (sci.electronics.design)
  • Re: Carte Blanche arrives!
    ... just spread too thin at the moment timewise... ... maybe someday. ... I missed out on the JTAG programmer. ... Actually had to go out and buy a PCI parallel port card in order to use it. ...
    (comp.sys.apple2)