Re: lcd interfacing


hi guys.... thanks for ur response.........i tried with the following
new modifications.

power on reset delay of 50ms
vss connected to gnd thru pot.
i had tried this lcd module with delay as well as by polling busy
flag.but it has not changed anything.

i got another lcd of jhd162a but later noticed that it is based on
same controller (ks0066).
however i m trying on that rite now with these new modifications.one
thing that i m not getting is that why this lcd is displaying bricks of
only one line

.

Relevant Pages

  • Microblaze to LCD module via FSL bus
    ... Spartan-3E starter board with an LCD. ... The interface and description of the LCD module are shown ... Port ( ...
    (comp.arch.fpga)
  • Re: Problem with PIC & LCD display
    ... LCD unit. ... you only need to send 1 nibble since the other half of the bus is not ... etc. close to the LCD module. ... The ground connection to the aluminium top panel was for convenience taken from the common 0v rail to the four control buttons and shared a return path on the PCB with the PIC and the LCD. ...
    (sci.electronics.design)
  • Re: Quality screen for colorimetry
    ... do not make the LCD portion of an LCD monitor. ... The integration of an LCD module with application-specific ... for connection to an image processor. ...
    (sci.engr.color)
  • Re: Gamma Values for LCD modules
    ... How do I calculate the gamma values for LCD module? ... design a LCD driver board. ...
    (sci.electronics.design)
  • Diver needs electronics help
    ... I am putting together an underwater housing for a video camera. ... use the built in viewfinder or the built in lcd do to the design ... I want to use an LCD module that I pulled ...
    (sci.electronics.components)