Re: CS8900 question



On Tue, 26 Sep 2006 23:39:20 +0200, Adib Taraben
<taraben.a@xxxxxxxxxxxxxxxxx> wrote:

In our new project we want to use cs8900 in the 8bit mode with a 16bit
uC (infineon C166).

We would like to use this chip, because this is on the Keil Eval board
and widely used.

Now I am reading the chip has some issues. The interrupt stops suddenly.
And that there are some workarounds.

So is there a reliable driver library for this chip?
Should I better use an other? Which?

Zilog eZ80F91. Much more power and less hazzle.

Mit freundlichen Grüßen

Frank-Christian Krügel
.



Relevant Pages

  • Re: Gottlieb SYS80B power question
    ... IRQ is staying high at about 4.5V (higher than the reading across C1). ... and if so would I need to replace the chip itself as ...
    (rec.games.pinball)
  • Wireless rt2500 on dual AMD64
    ... I've just popped my linksys wmp54g using the rt2500 chip into this new dual AMD64 box and after reading everything I can find about this new combo of parts I don't think it is a go. ...
    (Fedora)
  • Re: Fluke 79 acting up
    ... When I switch to the low ohms range, ... reading works, but AC volts reads 70mV when plugged into a 120V outlet. ... I invested in a moulded rubber surround for my 77, after repairing one ... that had been jarred and the main SMD chip had loosened. ...
    (sci.electronics.repair)
  • Re: Cause of audio amplifier failure?
    ... Jan Panteltje wrote: ... chip does not need it. ... Try reading ALL of it!! ... YOU FUCKING MORON. ...
    (sci.electronics.design)
  • Calculating resistors required
    ... The switches connected to my chip also want about 5V. ... but the motor is 3V. ... I guess I need a resistor to reduce my 6V to 5V, ... I've been reading about ...
    (sci.electronics.basics)