Re: 18F452 to SL811HS interfacing

Donald wrote:

Tristan Mumford wrote:
Hello.
I've been trying with limited success to interface a 18F452 uC to a
SL811HS USB host/slave IC.

I've pretty much debugged the software, but have hit a nasty brick wall
in hardware. I seem to be reading garbage from the IC. Ie no matter what
address I look at it's the same value. The really bothersome thing is the
omnipresent value changes every so often.

Is there anything I need in between these two chips? I'm using port D for
the databus and some of port C for the read, write and A0 lines.

The interface between the two is direct. Ie nothing in between. Should I
have something like a '245 or a network of pullups or something like
that?

Please post a schematic.

http://g.fondeville.free.fr/usb_en.html

Let's just say that is it. After the original post I received an e-mail
alerting me to the project. It was nearly identical to mine, so I
rearranged a few IO lines to make it compatible (except the uC on mine runs
at 8MHz). Then I changed a few "#define"s in my source to match.
Amazingly enough my alterations didn't change anything for better or worse.

Going from a feeling, it's like either D0 is stuck high, or the nWR line
isn't working. I can't find a sign of either being the case though.

Given that the value it regurgitates isn't changed even if I write a value
to an address and read it back immediately the problem is a little hard to
pin down.
--
-----> http://members.dodo.com.au/~izabellion1/tristan/index.html <-----
===== It's not pretty, it's not great, but it is mine. =====
.

Relevant Pages

  • Re: 18F452 to SL811HS interfacing
    ... SL811HS USB host/slave IC. ... I'm using port D ... The interface between the two is direct. ... last night I went through and checked again for open circuits ...
    (comp.arch.embedded)
  • Re: 18F452 to SL811HS interfacing
    ... I've been trying with limited success to interface a 18F452 uC to a ... SL811HS USB host/slave IC. ... the databus and some of port C for the read, ... The interface between the two is direct. ...
    (comp.arch.embedded)
  • 18F452 to SL811HS interfacing
    ... I've been trying with limited success to interface a 18F452 uC to a SL811HS ... USB host/slave IC. ... I've pretty much debugged the software, but have hit a nasty brick wall in ... the databus and some of port C for the read, ...
    (comp.arch.embedded)
  • Re: 18F452 to SL811HS interfacing
    ... I've been trying with limited success to interface a 18F452 uC to a SL811HS ... USB host/slave IC. ... the databus and some of port C for the read, ...
    (comp.arch.embedded)
  • Re: Additional Hardware Module with Xilinx MicroBlaze Processor
    ... a pcore for your LCD module. ... You can write to the fsl interface with the function putfslx, ... What I would like to do is define a GPIO port on the processor to ... and write to the FSL bus suffice? ...
    (comp.arch.fpga)