Re: STR912 ARM with SSD1906 TFT controller
- From: "Mo" <mo.mardi@xxxxxxxxxx>
- Date: Wed, 28 Feb 2007 08:34:03 -0600
I'mHi,
Any chance of the connections between the SSD1906 and the TX09 display?
TX09about to start a design using the STR710 micro, SSD1906 and a Hitachi
on(or a TX14) TFT display.
Any help would be appreciated! e.g. where do I connect the DTMG signal
the display? Does it just go to LDEN on the SSD1906?
That's correct:
LDEN - DTMG
LSHIFT - DCLK (Pixel Clock)
LFRAME - VSYNC
LLINE - HSYNC
Check the Pixel Clock polarity is ok, as the SSD polarity cannot be
changed in software - use an external inverter.
I can tell you the polarity is ok for TX14 and TX09D70, but not the new
TX09D40 or TX06.
Regards
Spen
Spen
In one of your replies you mention that the STR9 emi address is shifted
and describe how SSD 1906 A0 should be connected to 0V, etc.
Could you please tell me where you found this information? other than a
block diagram type suggested connection I can not find much on this.
regards
Mo
.
- Prev by Date: Re: Hardware Neural Network
- Next by Date: Re: Headhunter irony
- Previous by thread: Codewarrior vs. Cosmic C for Freescale 9S08
- Next by thread: Configuring Port A, Pin 4 as a general I/O pin in the PIC18F442
- Index(es):
Relevant Pages
|
