Re: Ultrasonic Sensor

On Jul 23, 8:45 pm, "Paul E. Bennett" <p...@xxxxxxxxxxxxxxxxxx> wrote:
Dibyendu wrote:
Hi,

I am trying to build an ultrasonic sensor module to detect and measure
the distance of an object, and got some problem :-)

Problem:
1. Not sure whether the transmitter send sound or not.
2. Not sure, Receiver work properly or not.
3. Circuit and code was not tested.

The configuration of my board is:

a) AT89C52. Microcontroller.
b) XTL freq. 11.0592 mhz.
b) 40 KHz ultrasonic transmitter and receiver.

Is the transmitter and receiver a pair of devices or just a single TX/RX
unit?

If they are a pair you may need to check that you are using the transmitter
for transmitting and the receiver for receiving.

You should also try and do one bit at a time. This link:-

http://www.eetasia.com/ARTICLES/2002MAR/2002MAR08_RFD_DA_AN.PDF

may help you. If you build just the interface portions you should be able to
see if they are working by scoping around the pins.

Once you have working TX and RX circuits you can then add the micro and
software and work on what ails those.

--
********************************************************************
Paul E. Bennett ....................<email://...@xxxxxxxxxxxxxxxxxx>
Forth based HIDECS Consultancy .....<http://www.amleth.demon.co.uk/>
Mob: +44 (0)7811-639972
Tel: +44 (0)1235-811095
Going Forth Safely ..... EBA.www.electric-boat-association.org.uk..
********************************************************************

Hello
I just had a rough look on the document. It is understandable, and
going to implement it soon (at the time of implementation i must read
this document again) :-)

.

Relevant Pages

  • Re: Remote trigger device for D300s --- Uh-oh - how about this amusing little
    ... YongNuo camera wireless remote control shutter release YN-128 will use ... It's supports the multistage frequency trim combination, the transmitter ... and the receiver establishes separately has four digit switch codes, ... friendly, not only has the independent power supply switch, but also has ...
    (rec.photo.digital)
  • Re: Remote trigger device for D300s --- Uh-oh - how about this amusing little
    ... YongNuo camera wireless remote control shutter release YN-128 will use ... It's supports the multistage frequency trim combination, the transmitter ... and the receiver establishes separately has four digit switch codes, ... friendly, not only has the independent power supply switch, but also has ...
    (rec.photo.digital)
  • Re: Bag Frequency Coordination Help......
    ... worth reading several times if you are doing a bag setup. ... UCR210 receiver in this test. ... frequency separation in MHz, then dB of desensing, then resulting ... We ran the same tests with reduced transmitter power (30 mW ...
    (rec.arts.movies.production.sound)
  • Re: Remote trigger device for D300s --- Uh-oh - how about this amusing little
    ... YongNuo camera wireless remote control shutter release YN-128 will use ... It's supports the multistage frequency trim combination, the transmitter ... and the receiver establishes separately has four digit switch codes, ... friendly, not only has the independent power supply switch, but also has ...
    (rec.photo.digital)
  • Re: Sennheiser EW100 G2
    ... I am just learning about sound, so forgive me if I pick on your wisdom. ... would like to know what you recommend I set the AF OUT on the receiver ... and the SENSITIVITY setting on the transmitter of the EW100 as settings ... does anybody know where I can get typically used frequencies from ...
    (rec.arts.movies.production.sound)