Re: MCU w/ integrated graphics LCD controller suggestions?
larwe wrote:
On Jul 26, 7:57 pm, Bob <SkiBoy...@xxxxxxxxxx> wrote:
Hi all,
I'm looking for a single chip solution that integrates an Epson-like
(135x family, e.g.) LCD controller and some flash with a modest MCU.
I second Ulf's suggestion to look at driving the LCD "manually" but of
course other parts beside Atmel's can achieve this - ST, Philips
(NXP), etc.
hmmm. Or maybe something that's designed to output video - like a
BlackFin PPI port?
Bob
.
Relevant Pages
- Re: cheapest FPGA?
... I can do it with a microcontroller, but the only MCUs with the hardware I need (TFT LCD controller) ... tend to come with lots of other stuff (ethernet, large flash, USB etc.) which I don't need. ... At some point I may look at the NXP ARM9 LCD part which can load from SPI but it's in a BGA package ... rates than the MCU could handle. ...
(comp.arch.fpga) - Re: MCU w/ integrated graphics LCD controller suggestions?
... LCD controller and some flash with a modest MCU. ... I second Ulf's suggestion to look at driving the LCD "manually" but of ...
(comp.arch.embedded) - Re: Embedded Basic interpreter recommendations?
... You can log into the MCU ... interactively, write and debug your program, save it to an internal flash ... filesystem, run commands in immediate mode, interactively debug, etc. ... StickOS BASIC allows you to define "pin variables" that are bound to pins ...
(comp.arch.embedded) - Re: rom to ram compression
... if you have 128k flash and your image is 130k compressing it ... Choosing a MCU with bigger flash if often no option ... To compress an image into the flash to save space is a good idea. ... 130K image inside of 128K Flash would need 130K RAM. ...
(comp.arch.embedded) - Re: MCU dead due to bad code?
... via JTAG. ... Furthermore no activity on the MCU bus. ... via JTAG initialization- and flash program loaded into internal RAM ... (I'm using the Amontec Chameleon with the "Raven 8MHz witout Reset" ...
(comp.arch.embedded) |
|
