Re: elimination of intercharacter gap in RS232 stream?
- From: cbarn24050@xxxxxxx
- Date: Wed, 10 Oct 2007 10:00:22 -0700
On Oct 10, 5:50?pm, "Bo" <b...@xxxxxxxxxx> wrote:
Writing an Embbeded Linux app for a PC104/Versalogic board. Linux 2.6.14.17.
Using write() to transmit data packets to another PC104 board. If I write()
30 bytes, sometimes there is a 2-5mS gap in the middle of the
transmission, usually at about byte 15-20, but sometimes at byte 29--as seen
on a scope. Tried using low latency setting when
opening the port--but this made no difference. This is causing difficulties
for the receiving end-- and we have yet to add two more serial ports to the
application.
Any ideas on how to force continous transmission of the data?
Thanks,
Bo
You would do better to solve the problem at the receiving end, thats
where your real problem is.
.
- Follow-Ups:
- Re: elimination of intercharacter gap in RS232 stream?
- From: Paul Keinanen
- Re: elimination of intercharacter gap in RS232 stream?
- References:
- Prev by Date: Re: Delay Routine: Fully-portable C89 if possible
- Next by Date: Re: elimination of intercharacter gap in RS232 stream?
- Previous by thread: elimination of intercharacter gap in RS232 stream?
- Next by thread: Re: elimination of intercharacter gap in RS232 stream?
- Index(es):
Relevant Pages
|
