Re: PIC controller for a motor (PWM)

From: DJ <DJ@xxxxxx>
Date: Thu, 11 Oct 2007 10:21:40 +0200

Use the PIC output to drive the gate of a power FET. If the control
is in the high side, use an optoisolator to drive the gate.

I've done that recently using FET's full bridge (left-right). I can send schematic if you need a reference. Write me on: tomasz @ (remove-this) mikran pl
.

Follow-Ups:
- Re: PIC controller for a motor (PWM)
  - From: Donald Harris

References:
- PIC controller for a motor (PWM)
  - From: Vicente
- Re: PIC controller for a motor (PWM)
  - From: Donald Harris

Prev by Date: Re: elimination of intercharacter gap in RS232 stream?
Next by Date: Re: Delay Routine: Fully-portable C89 if possible
Previous by thread: Re: PIC controller for a motor (PWM)
Next by thread: Re: PIC controller for a motor (PWM)
Index(es):
- Date
- Thread