Ampro MightyBoard USB issues?

I'm using an ampro MightyBoard 800 series of single board PC's and
running embedded XP. I'm getting odd USB hangs on various ports at
various times. Basically, the USB device does not respond after
working for some time. The problem is resolved by disconnecting and
reconnecting the USB cable.

Any known Ampro/XP issues out there? Help is greatly appreciated -
thanks -
Brian

.

Relevant Pages

  • Re: AHCI - remove probing of ata2
    ... ACPI: bus type pci registered ... registered new interface driver hub ... USB Universal Host Controller Interface driver v3.0 ... hub 1-0:1.0: 2 ports detected ...
    (Linux-Kernel)
  • Re: Help interpreting AHCI failure messages
    ... investigate I decided to try putting the root fs on a usb memory stick ... PERCPU: Allocating 57344 bytes of per cpu data ... registered new interface driver hub ... hub 1-0:1.0: 6 ports detected ...
    (Linux-Kernel)
  • Usb problems on 7.0 RELEASE
    ... Earlier I reported usb problems on this list. ... 686-class CPU) ... <Enhanced SpeedStep Frequency Control> on cpu0 ... 2 ports with 2 removable, ...
    (freebsd-stable)
  • Re: Frequent USB mouse disconnections under load with RELENG_7]
    ... disconnections of the mice. ... A mouse attached via a second pair of USB ports, ...
    (freebsd-stable)
  • OOPS in 2.6.19.1, connected to nfs4 and autofs4
    ... ACPI: Local APIC address 0xfee00000 ... Linux Plug and Play Support v0.97 Adam Belay ... USB Universal Host Controller Interface driver v3.0 ... hub 1-0:1.0: 2 ports detected ...
    (Linux-Kernel)