Re: 300 mA from a microcontroller pin

Tomás Ó hÉilidhe:

I'll post a picture of the relevant part of the circuit now in a few
minutes.


http://img266.imageshack.us/img266/4861/ledsetupug6.jpg

As you can see, I've pins coming from microcontroller going to the shift
register.

--
Tomás Ó hÉilidhe

.

Relevant Pages

  • Re: Multiplexing - how to speed up
    ... Currently I'm testing with 5 cascaded shift registers (serial in, ... After adding the 5th shift register the image started flickering. ... void shift_byte ... internal buffer but not to the output pins of that register. ...
    (sci.electronics.design)
  • Re: Multiplexing - how to speed up
    ... Currently I'm testing with 5 cascaded shift registers (serial in, ... After adding the 5th shift register the image started flickering. ... void shift_byte ...
    (sci.electronics.design)
  • Re: Impact 8.1 problems with non xilinx device in chain
    ... I am unfamiliar with the Atmel part in question but am quite certain that iMPACT is OK with instruction register lengths down to 2 bits. ... My cursory examination of the Atmel data sheets indicates that the part has 2 pins that control the test modes - a TST and the JTAGSEL. ... I'm wondering if the FPGA pins are connected to either of these pins and perhaps interfering with the boundary-scan chain during configuration? ... on my board was the first in the JTAG chain followed by 4 other non-Xilinx devices. ...
    (comp.arch.fpga)
  • Re: device for converting binary strings into states for switches
    ... For 8 switches I think that I got the idea, ... into a register). ... you need a serial-to-parallel shift ... register clock and the latch clock. ...
    (sci.electronics.basics)
  • Re: 8 Bit Random Numbers
    ... the shift direction. ... the working register and then shift the register again which rolls ... the same logic as a simple single-register LFSR, ... The Nth memory location is ...
    (sci.electronics.basics)