Re: 1st Time PCB Design
- From: Brendan Gillatt <brendanREMOVETHIS@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx>
- Date: Fri, 21 Dec 2007 21:01:33 +0000
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
benn wrote:
Id like to design a simple board over the holidays, I've never layed
out a board before, so Im a little nervous :)
I've started the schematic capture, and the routing and found a cheap
place to get it fabd. (I dont want to muddy the waters by doing a
homebrew pcb myself!)
Id like to go with whatevers the cheapest to manufacture, so Im
thinking about the $65 single sided boards at www.olimex.com/pcb/ .
However, Im a little unsure about their requirements:
Might I suggest you take a look at batchPCB(.com) - they do a nice double
layer for pretty cheap. I sent off a 90mm x 90mm board and a 30mm x 20mm
board last night which cost me, altogether, $57 including postage to the UK.
- --
Brendan Gillatt
brendan {at} brendangillatt {dot} co {dot} uk
http://www.brendangillatt.co.uk
PGP Key: http://pgp.mit.edu:11371/pks/lookup?op=get&search=0xBACD7433
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.3 (MingW32)
iD8DBQFHbCmtkA9dCbrNdDMRAli2AKCgjP8R0GENEoYYjKCV9S8ixU5NtgCg0Jvh
y8nhJl56wsgfUJ3Ltzxcvi4=
=BhfG
-----END PGP SIGNATURE-----
.
- References:
- 1st Time PCB Design
- From: benn
- 1st Time PCB Design
- Prev by Date: Re: 1st Time PCB Design
- Next by Date: Allegro Footprints
- Previous by thread: Re: 1st Time PCB Design
- Next by thread: Re: 1st Time PCB Design
- Index(es):
Relevant Pages
|
