Re: 93c46 protocol

cell wrote:
Hi all,

Is it using 3 wires or 4 wires protocol?

I find that if I fix to set the CS high. The reading is no working.

So why someone say that it uses 3 wires?

BR,

Terry


Why do gmail addresses not understand how to read a manual ??

donald
.

Relevant Pages

  • Re: Desktop vs handheld multimeter?
    ... Checking zero ohm gives 00.6 ohm. ... I plan to buy a reliable multimeter within 6 months depend on the ... A reading of .6 ohm is not unusual for a cheap meter. ... since you have to deal with 4 wires. ...
    (sci.electronics.equipment)
  • Re: Desktop vs handheld multimeter?
    ... Checking zero ohm gives 00.6 ohm. ... I plan to buy a reliable multimeter within 6 months depend on the ... A reading of .6 ohm is not unusual for a cheap meter. ... It is much more accurate for a low resistance measurement, but slightly less convenient since you have to deal with 4 wires. ...
    (sci.electronics.equipment)
  • Re: Kicker kx600.1 Wont power on :(
    ... *multimeter, but when I hooked up the wires to the amp, the multimeter ... *wouldnt give me a straight reading. ...
    (rec.audio.car)
  • Re: 93c46 protocol
    ... cell wrote: ... I find that if I fix to set the CS high. ... The reading is no working. ... So why someone say that it uses 3 wires? ...
    (comp.arch.embedded)
  • Re: Bad computer monitor...
    ... I pulled the 4-pin connector off the circuit board, the Blue and Red wires make one loop, they are reading 0.7 ohms, the Yellow and Brown wires make the second loop, they reading 7.6 ohms. ...
    (sci.electronics.repair)