Re: what is your take on evaluation boards and dev kits?



"answers" <answers4forums@xxxxxxxxx> skrev i meddelandet
news:l8qdnfLnofjWn6HVnZ2dnUVZ_gidnZ2d@xxxxxxxxxxxxxxx
Hi All,

Please guide me in getting a ARM or other processor Development board with
USB, SPI, UART, etc protocols, also board must be Linux portable.

I am interested in carrying my hobby work, see that the board is cost
effective.

I am not looking for micro-controller boards.

Please let me know.



The ATNGW100 board has an AVR32 CPU core.
16 MB of Flash, 32 MB of SDRAM.
Supported by linux-2.6.25.
www.atmel.no/buildroot

Has USB device, SPI, UART as well as "etc.".
Should be $89 in single qty.

--
Best Regards,
Ulf Samuelsson
This is intended to be my personal opinion which may,
or may not be shared by my employer Atmel Nordic AB


.



Relevant Pages

  • Re: what is your take on evaluation boards and dev kits?
    ... USB, SPI, UART, etc protocols, also board must be Linux portable. ...
    (comp.arch.embedded)
  • Re: Protocol analyzer for I2C, SPI, USB
    ... We are looking for a good Protocol Analyzer to use mainly for I2C, SPI ... similar) other protocols. ... UART and SPI data. ...
    (comp.arch.embedded)
  • Re: MAX3100 Uart problems
    ... Devices which start and accept the config command ok at room temp, refuse to start ok at 60 deg C. ... The SPI communications, seem to get a bit borderline at higher temperatures. ... Yes they are tricky, but having got the details right, they seem to work fine on the uart side. ... Either they start up and transmit correctly at the 4800 baud rate, ...
    (sci.electronics.design)
  • Re: MAX3100 Uart problems
    ... Anyone else using the MAX3100 SPI UART? ... and accept the config command ok at room temp, refuse to start ok at 60 ... Rx and Tx enabled, and only the last 4 bits, which define the baud rate, ...
    (sci.electronics.design)
  • Re: AT91SAM7S256-128-64-321 USB and USART usage (clocking)
    ... UART peripheral on the AT91SAM7S256-128-64-321, ... have the main clock MCK from an external crystal. ... MCK derived directly, I mean, does MCK have the same frequency as the ... USB needs a couple of clocks: clock from the PLL at 48MHz ...
    (comp.arch.embedded)