Re: Developing Application software for a USB host

What I have seen in the documentation of the ATM6124 is it uses Bulk
endpoints for transfer usually on the other hand our device uses
isochronous usually.


Yes I have tried the ATM6124 device driver for our device, I think It does
enumeration, but when i run the application exe from Atmel i dont get any
relevant data from USB device. This exe uses readfile and writefile
functions to send and receive data.

i am using windows 2k. Which API it has to talk directly to the USb
device?

Do i need to refer MSDN website to know how to access isochronous endpoint
and how to do data transfer with those?

I dont know whether Atmel allow us to use the device driver they have
developed for their test board.

I have seen the documentation of the libusb ..It does not support
isochronous.

Thanks for your valuable comments
Faiyaz




.

Relevant Pages

  • Re: Intel 6300ESB SATA and TIMEOUT - WRITE_DMA
    ... and sponsoring time to work on it is *the* way to get ATA ... I dont know the stand of the community on which SATA controller to focus developement on. ... there is no way around a 3ware card. ... I've been helping with the saa7135 but I have the same issue with chipset documentation... ...
    (freebsd-hackers)
  • Re: Documentation and Usability
    ... > improvement and might be slightly un-helpful to noobies. ... I dont think noobies are expected ... > Solution one will perpetuate the inadequate documentation problem. ...
    (Debian-User)
  • Re: Examples of USB devices
    ... If you plan to develop a new USB device, and you plan to primarily use it under ... So carefully study the limitations given by MS Windows BEFORE you start ... Endpoints may be limited due to cost reasons. ... one driver for each interface. ...
    (microsoft.public.development.device.drivers)
  • Re: Ethernet data reading
    ... when a Packet is recieved the code enterd to a part that i should read ... but now i dont know what can i do. ... When I look at the documentation, I see no reason that you could not use the same code, with "fid" replaced by the reference to your serial object. ...
    (comp.soft-sys.matlab)
  • Re: IssueBulkTransfer
    ... > for my USB device. ... > the 4.2 release according to MSDN documentation. ... > when I attempt to issue the OpenPipes, ... > that if the prototypes are wrong then perhaps the structures are also wrong, ...
    (microsoft.public.windowsce.platbuilder)