Re: Need good quality Audio output through LPC21xx controller



On Sep 30, 1:23 pm, Martin Griffith <mart_in_med...@xxxxxxxx> wrote:
On Mon, 29 Sep 2008 22:28:18 -0700 (PDT), in comp.arch.embedded

angadd...@xxxxxxxxx wrote:
We are working on a project based on Vehicle tracking system.In one of
our module we are using audio(voice)  for Public transport  system.As
if for now we are using  filters and a power amplifer We are not able
to get good quality audio output with this setup.

Item used:
Lpc2132 with MMC card interface ,High pass filter+ Low pass filter+
Audio Amplifier+ Speaker

Requirement:

Good Voice quality annoucement system for Public transport System

Are you trying to use PWM to play the audio, or a  DAC?
How are you recording the audio, bit rate and depth?

mar


I am using PWM ,.raw format little indian 16 bit 8khz<
.



Relevant Pages

  • Re: PWM -> Audio
    ... using 8-bit audio data sampled at 8 kHz to ... Multiply the PWM rate by N, reusing the data N times (or perhaps ... Implement the "traditional" class-D LC filter output. ... We often use delta-sigma instead of pwm to make 1-bit dac outputs. ...
    (sci.electronics.design)
  • Re: PWM versus codec
    ... > I am worried about how hardcore the filtering needs to be after the PWM ... I dont have weeks to design the greatest filter ever....Are ... Depending upon what your audio format is in to begin with, ... maximum 10-bit audio samples. ...
    (sci.electronics.design)
  • Re: PWM -> Audio Output
    ... The audio output works but the quality is not quite there. ... I've discovered that I can remove these artifacts by changing the PWM ... My PWM output feeds through a first order RC filter which is set to cut ... The poppiness is an absolutely sonically repeatable sound that can ...
    (comp.arch.embedded)
  • Re: Low-pass filter and amp design
    ... My application is portable, battery based. ... I'm looking to generate an audio signal from a PIC using ... I need to clean up the PWM signal and output it to a speaker at ... A filter cut off of 4.5kHz is not the right choice for a sampling rate of 9kHz. ...
    (sci.electronics.design)
  • Re: Simple PWM volume controller. Could it work?
    ... >> pass filter, to get rid of the high frequency component, and that's ... scaled by the PWM ratio. ... >> potentiometer that gives 0 V on the PWM output, no audio is getting ... A better switch than the ancient 4066 ...
    (sci.electronics.components)