Re: Help for initializing a BW Graphic LCD module
- From: interrogativo <vento_74@xxxxxxxxxxx>
- Date: Sat, 21 Mar 2009 01:30:51 -0700 (PDT)
On 18 Mar, 02:19, Ben Bradley <ben_u_brad...@xxxxxxxxxxx> wrote:
On Tue, 17 Mar 2009 14:08:28 -0700 (PDT), interrogativo
<vento...@xxxxxxxxxxx> wrote:
Hi all!
I've an AVR ATmega168 connected to a G1212x02 from CCT :
http://www.cct.com.my/Products/Graphic%20Module/PG58-G1212X02.pdf
It embeds a NT7506 controller from Novatek.
You need to find the data sheet for the controller. This page lists
a different part number for the controller (perhaps it's the same or
compatible part by a different manufacturer):http://www.cct.com.my/index.php?dis=LCM02
This chip needs alot of params: step-up voltage, resistors and so on.
The LCD module datasheet doesn't explain too much.
Can somebody help?
Sorry, the correct LCM model is G1212x05 and I have the datasheet for
it. Moreover, I do have the datasheet for NT7506.
There's a lot of electrical parameters you can set by software and
most of them depend on how the controller is wired on the LCD module.
Since such details are not explained in the LCD module datasheet, I
don't know how to set them.
.
- References:
- Help for initializing a BW Graphic LCD module
- From: interrogativo
- Re: Help for initializing a BW Graphic LCD module
- From: Ben Bradley
- Help for initializing a BW Graphic LCD module
- Prev by Date: Re: Off-the-shelf embedded 'counter' datalogger
- Next by Date: Re: Motor Operation Detection?
- Previous by thread: Re: Help for initializing a BW Graphic LCD module
- Next by thread: GCC for Infineon TriCore
- Index(es):
Relevant Pages
|