Re: Debugging TMS320, Step 1
- From: Olimex <tsvetanusunov@xxxxxxxxx>
- Date: Mon, 17 Aug 2009 23:21:23 -0700 (PDT)
On 17 Авг, 14:27, "Radly" <da...@xxxxxxxxxxxx> wrote:
I maintain the code for a controller based on the TMS320R2811. My system
uses the boot loader to download the execuable code from a host app, so I
need to know how to set breakpoints after the download is done. Someone
else, long since gone, did the original development, so I missed that stage
of the development. So far, I've been able to get by without a debugger,
but those days are over. I am now trying to figure out how to get started
with simple debugging (breakpoints and reading and setting variables). I
understand that I can order a USB JTAG cable, but then what? Where can I
find a good "getting started" guide? My questions are along the lines of
"how do I tell Code Composer I have the device hooked up?" "How do I set a
breakpoint in code the processor hasn't downloaded yet?" That sort of
thing.
I'm using CodeComposer 3.3.82.13, freshly updated today.
please check http://www.olimex.com/dev/tms320-jtag-usb.html it may be
what you want, low cost (EUR 55) programming and debugging tool for
TMS320 family
a bit slower than the other expensive USB JTAGs but does same step,
breakpoints etc
Best regards
Tsvetan Usunov
Olimex ltd
---------
Development and prototype boards, programmers, debuggers for ARM, AVR,
MSP430, MAXQ2000 and PIC at http://www.olimex.com/dev
Fast PCB prototypes in 3-5 working days for EUR 30 at http://www.olimex.com/pcb
.
- Follow-Ups:
- Re: Debugging TMS320, Step 1
- From: Antoon
- Re: Debugging TMS320, Step 1
- References:
- Debugging TMS320, Step 1
- From: Radly
- Debugging TMS320, Step 1
- Prev by Date: Re: Debugging TMS320, Step 1
- Next by Date: Bluetooth audio
- Previous by thread: Re: Debugging TMS320, Step 1
- Next by thread: Re: Debugging TMS320, Step 1
- Index(es):
Relevant Pages
|
