Re: Test pls ignore

Jessica Griego wrote:
"Erwin Moller" <Since_humans_read_this_I_am_spammed_too_much@xxxxxxxxxxxxxxxx> wrote in message news:4924277b$0$185$e4fe514c@xxxxxxxxxxxxxxxxx
Jessica Griego schreef:
"Dave" <davenNOSPAMmanvel@hotmailNOSPAMdotcom> wrote in message news:ca170$4921f3d3$19511@xxxxxxxxxxxxxxxxxxxx
ignore
** Posted from http://www.teranews.com **
Dave,

There are newsgroups that exist ENTIRELY for you to test with. Please use them instead of annoying the newsgroups you intend to use, which is less likely to get you plonked before you even post a 'real' message.

Your signal to noise ratio is nearing 1 ... which is the idiot's plane of existence. Please increase the signal and reduce the noise.
Hi Jessica,

Just curious.
I could be wrong, but signal to noise ratio:
ratio = (Power signal)/(Power noise)

So isn't his signal to noise ratio extremely small instead of nearing 1?

Yes, Erwin, that's the typical math involved. Less noise means clearer signal. 'Nearing' does not indicate from which direction the approach began, only that a weaker signal was being reached...a value of 1.

500 / 500 == 1
500 / 200 == 2.5
500 / 100 == 5

Notice the noise is reduced and the signal throughput has increased. I'm not sure where you're going with this though. I have to agree, "his signal to noise ratio *is* extremely small". If you believe it is less than 1, you are saying the amount of noise is greater than the signal. Again, I have to agree. :)


Silly question but....what the heck are you both talking about?
.

Relevant Pages

  • Re: Test pls ignore
    ... "Erwin Moller" ... There are newsgroups that exist ENTIRELY for you to test with. ... Your signal to noise ratio is nearing 1 ... ... Please increase the signal and reduce the noise. ...
    (alt.php)
  • Re: Test pls ignore
    ... "Erwin Moller" ... There are newsgroups that exist ENTIRELY for you to test with. ... Your signal to noise ratio is nearing 1 ... ... Please increase the signal and reduce the noise. ...
    (alt.php)
  • Re: Test pls ignore
    ... Please use them instead of annoying the newsgroups you intend to use, which is less likely to get you plonked before you even post a 'real' message. ... Your signal to noise ratio is nearing 1 ... ... Please increase the signal and reduce the noise. ...
    (alt.php)
  • Re: Signal to Noise Ratio
    ... the signal to noise ratio of Iain Church's cathode follower pre-amp is still ... The noise residual was mostly hum, ... a Quad Mk2 has a voltage gain of 7.1 times when set to 8 ohms load. ...
    (rec.audio.tubes)
  • Re: Test pls ignore
    ... Erwin Moller wrote: ... Please use them instead of annoying the newsgroups you intend to use, which is less likely to get you plonked before you even post a 'real' message. ... Your signal to noise ratio is nearing 1 ... ... Please increase the signal and reduce the noise. ...
    (alt.php)