le dahut enlightened us with: > Is there a way to get network parameters (number of network
> interfaces, ip address(es), DNS, gateway) on a linux station using
> python 2.3 ?
Sure.
- number of network interfaces, ip address(es), gateway: read from /proc
- DNS: read /etc/resolv.conf
Sybren
--
The problem with the world is stupidity. Not saying there should be a
capital punishment for stupidity, but why don't we just take the
safety labels off of everything and let the problem solve itself?
Frank Zappa
.
Re: Gateway reset on reboot (was: xnptd insane after reboot) ...network interface selection -> remove a network interface (done for all ...network interfaces; trying to blast out the old gateway value that just ... Here's the output that smitty is giving me: ... set the gateway,... (AIX-L)
RE: Using Fedora as firewall. ... configuring two network interfaces.... This sounds like you specified a default gateway on the eth1 interface. ...network interfaces. ... Just make sure you edit the eth1 config and make ... (Fedora)
IPSec (i.e. Freeswan 2.x), Linux kernel 2.6 no longer masquerading (NATing) connections ... kernel and thus the virutal ipsecN interfaces once used for IPSec ...Cisco IPSec clients for Linux have done this for a while now), ... makes NAT'ing VPN traffic on a gateway difficult - if not impossible. ...network across an IPSec tunnel? ... (comp.os.linux.networking)
Re: PIX 506E Multiple LAN-Areas... ... :> 192.168.100.128/25 Gateway should be 100.129 on the PIX...:network per interface with current OS versions. ... The 506E with current software allows two virtual interfaces,... (comp.dcom.sys.cisco)
Re: How to save the Firewall Zone setup for wireless Interface setting ... Run YaST2 again, and setup the card to managed, start on boot, no usercontrol, ... no network manager, and save. ... # setting up a lot of interfaces.... # Switch on/off debug messages for all network configuration stuff. ... (alt.os.linux.suse)
